This product is only suitable for PS3 consoles which are less than or equal to version 3.55 

PS Jailbreak2 new feature: Upgradable, No need HD disc.

PS Jailbreak2 is a USB plug and play solution that installs in seconds, keeping your valid warranty seal in tact.

Easy to use installer and GUI takes you step by step.

Compatible with all production models FAT and SLIM. Supports all regions: USA, JAP, PAL and KOREA

PS Jailbreak disables forced software updates and will never brick your console.

Supports all games (it does not allow backups of bluray movies , dvd movies , or past consoles games)

Backup games to your internal hard drive or external hard drive through USB, and boot directly off GUI. Eliminating the need for expensive blueray burners and costly blank media.

Play backups off your hard drives 2x as fast as off the blueray drive. This eliminates lags and glitches to provide you with smoother game play.

Open up your console to a new generation of homebrew applications. Load homebrew apps/games off any USB hard drive/flash drive.

Fully updatable with new features/updates by connecting PS Jailbreak to any computers USB port.

Upgrade Instruction:

Download and install Atmel FLIP 3.4.2

When installed，go to installation folder, namely Atmel\Flip 3.4.2\usb\, find libusb0.dll and libusb0_x64.dll, copy them to folder Flip 3.4.2\bin

Then plug PSjailbreak into USB port in PC, the red green light will light up.

Meanwhile PC reminds you that unusable unkown device found.

Ignore it, wait for a few seconds, new hardware AT90USB162 DFU will be found, pc asks you to provide driver,

choose USB folder in Flip as the Install Path, for example Atmel\Flip 3.4.2\usb\

then the installation begins.

When the driver is installed, we can write on AT90USB162.

Run Flip, go to Device -> Select..., and choose AT90USB162

Then go to File -> Load HEX File...

Choose the HEX file you want to write into,

PSjailbreak2_v1_0913.hex

PSjailbreak2_lv2_test0919.hex

PSjailbreak2_lv2_hermes_beta0923.hex

PSjailbreak2_jevinskie_3_01_beta1005.hex

PSjailbreak2_jevinskie_3_15_beta1005.hex

PSjailbreak2_jevinskie_3_41_beta1005.hex

PSjailbreak2_hermes_v3_beta1006.hex(New!)

Attention: HEX must be put in the English path so that it can be read

Then you can see HEX file parsed shown in the left bottom.

Then go to Settings -> Communication ->USB, choose OPEN USB port.

Then the chip is open and ready to be written.

Check HEX File, make sure if it’s the right HEX that you want to write into.

Choose RUN in the left bottom, then the chip is being written. It will be done in a few seconds. You will see Verify PASS in the left bottom when it’s finished.

Now the chip has been written. Turn off Flip and unplug the PS jailbreak2 dongle out of PC.